Hygger Aquarium Heater Submersible Fish Tank Heaters with LED Temperature Display and External Temperature Controller

Hygger 50W 100W Submersible Mini Aquarium Heater with External Controller and Built-in Thermometer, for Betta Turtle

· [Digital Display]with led display on the midle of the heater front side, when the fish tank heater is heating, there indicator light above the digit is on red, when it stop heating, the light is off. The heater with a built-in thermometer, when temp setting is done, the led will show the water temp all the time. The led will display the set temp digit only when you press the controller

· [Reliable Thermostat]this an automatic aquarium thermostat, after finishing the temp setting, you can be confidence on that it will maintain the tank water at the temp you set. The tank heater will stop heating when the water temp reaches to set temp, it will restart to heating when the water temp is 1℉ off the set temp. If the water temp is over 95℉, the heater will auto shut off and led displaying HH, it will work normally again when the water temp is lower than 95℉

· [Shut off When Out of Water]please note that this a fully submersible aquarium heater for fresh water and saltwater tank, when the top part of the heater is out of water it will auto shut off and the led displaying E1, when fully in water again it will return to normal work again

· [Compact Small Heater]110-120V/60HZ oval shape design little aquarium heater, fast heating for small fish tank. 50W tank heater is for 1-6.5gallon, 100W tank heater is for 6.5-13 gallon. Heater Dimension: 2.7x1.4x 4.5 inch. The power cord is 5ft, long enough for use indoors. With 2 strong suction cups at the back side of the betta heater, it's easy to install it on to glass, acrylic or plastic tank

· [External Controller]easy to set the temp on the controller, only show farenheit temp, you can set the temp range from 63℉ to 94℉, temp accuracy 1℉. Every time you set the temp, just press the button over and over until it reaches to your desired temp, then stop and wait the digit flashing for 3 times, then setting is done. Keep the controller away from water, it's not waterproof